Blen Dor Jeep Grand Cherokee Blend Door Heater Repair 99/04 Jeep GC Single Zone

Description

Do you have Recirculation Door problems or the fault code #52?
Then you could use the
"
FREE
"
-
NO
Dash Removal
-
Recirculation Door Fix
Included Free with purchase of the Blen Dor Store's
No dash removal dual control blend doors
No dash removal single control blend doors
“The Blen Dor Single Control
(ndr)
”
1999/2004 Jeep Grand Cherokee Blend Door Heater Repair
NO
Instrument Panel removal
D
o
I
t
Y
ourself
(DIY)
savings of 0 to ,200
The Blen Dor Store has a
FREE
No Dash Removal Recirculation Door Fix
The
Blen Dor Recirculation Door (ndr) fix will let the blocked air thru without removing the dashboard.
Included free, Only
with the purchase of a Combined Item - No Dash Removal blend door item
See below for a list of the other Blen Dor Store Items
For more helpful information please visit my website
The Blen Dor Store
The Blen Dor Single Control
(ndr)
is an easy repair for one of the most common heater problems of the 1999 - 2004 Jeep Grand Cherokee.
The Blen Dor Single Control
(ndr)
repair is done thru the glove box opening.
No
dashboard removal.
No
draining of the radiator.
No
evacuating the AC system.
No
recharging the AC system.
!!
This is a User Friendly easy to install blend door repair kit!!
A very easy repair for anyone that can handle a tool.
Only two parts to install, after the heater box is opened.
Put the one part door assembly in place.
Push the drive connector into the shaft of the door assembly.
Close the heater box and install the actuator motor.
Recalibrate the system.
The job is done!
The Blen Dor Store Design
We have designed and engineered an uncomplicated two piece unit.
The Blen Dor Single Control
(ndr)
kit will replace the plastic drive connector piece and the plastic blend doors with
solid aircraft quality aluminum parts
.
The blend door shaft is a ½” solid piece of aluminum rod machined to fit.
The two doors are 1/16” aluminum sheet stock tig welded onto the door axle shaft with a 1/4” vinyl foam rubber
(High adhesion strength adhesive with a very good temperature range)
covering applied to both sides of the door panels, all to make a one piece assembly.
The second piece is the drive connector it is a ½” solid piece of aluminum rod with steel roll pins.
The drive connector is machined to fit the actuator motor and to fit onto the end of the blend door axle shaft assembly.
The Blen Dor Store parts are designed to last longer than the vehicle.
The Blen Dor Single Control
(ndr)
kit Includes:
One aluminum single control blend door part
One aluminum drive connector
Paper instructions with plenty of pictures to help with the installation.
One multipurpose bit for cutting the access hole in the HVAC box.
Aluminum tape to cover the groove around the access hole panel.
The Blen Dor Store designed
“
A very easy repair for anyone that can turn a screwdriver and cut a piece of plastic”
No
fumbling around inside the heater box trying to assemble multiple parts that you can’t see.
No
small parts to drop or loose inside the heater box.
No
screws to come loose or strip, causing you to have the same problem again in the future.
The work is done thru the glove box opening and should take less than an hour for a beginner to complete.
The tools you will need are a phillips screwdriver, regular flat screwdriver, pliers, a RotoZip, Dremel, or other rotary type tool for cutting into the plastic heater housing.
As the heater box is a soft type of plastic, you could also use an Exacto knife with a saw blade or any number of saws or knives if you don’t have a rotary tool.
A standard drill with a right angle handle will need an extension to keep the drill outside of the heater box.
We will supply the blend door assembly, detailed instructions with plenty of pictures to help with the installation, and other items to complete the repair, including a multipurpose bit to cut open the plastic heater box.
The first thing to do is check for a blend door failure
In the MTC
(Manual Temperature Control)
single zone systems the most common symptom of a blend door failure is:
The driver & passenger side loses heat
(Or only the passenger side has lost heat)
and you do not have control of the
air conditioning
temperatures, it just blows out cold air no matter what the temperature is set at.
That is the common symptom of a blend door failure.
As the MTC single control system does not have a fault code you can read from the dash.
To check for a blend door failure if you have the 99/04 Jeep Grand Cherokee with the Manual Temperature Control system (MTC).
You will check for a broken blend door manually.
Check items #
270681028817
or
330508975748
for a
"
FREE
"
Blen Dor Recirculation Door
(ndr)
Fix
.
To check the blend door manually:
1.
Lower the glove box.
There are two plastic tab stops sticking up past the top of the glove box that hit against rubber stops.
Fold these rubber pieces to the side
(They are attached only on one side so as to act as a hinge point)
2.
Remove the dampener arm on the right side of the glove box by sliding the end up and out of the key slot.
The glove box should be hanging down at this point.
3.
You should see an actuator motor to the left of the glove box opening.
Remove the wire connector at the top of the motor.
Remove the two screws holding the actuator motor in place.
4.
Turn by hand the white plastic drive connector that the motor was attached to.
It should turn a little less then 90 degrees.
If it turns more than 90 degrees, the limit pin or stop points and the blend doors are broken.
If an actuator motor does not rotate when you turn on the system, that
does not
mean the motor has failed.
The control module shuts off an actuator motor if it makes one revolution with no resistance.
If you have a Dual control (AZC) HVAC system - You can use this single control blend door item.
With the Blen Dor Single Control
(ndr)
kit in a dual control system, you can only use the driver’s side temperature control knob.
This is the comprise between an inexpensive easy repair and the time consuming dashboard removal or the cost between 0, ,500
or more to have the dealer do the repairs.
The driver side control knob is the only one that will control the heat for both sides, the passenger side control knob changes the display numbers only, it does not control any of the heat output.
Guaranteed
for as long as you own the vehicle
.
If a part fails, that part will be exchanged for a new part.
Free shipping of the new exchange part.
The customer
must contact
me by email thru Ebay before returning the part. The customer is responsible for the cost of returning the part.
There
will be
a handling fee of .00 if the item is returned without first notifying the Seller by email thru Ebay.
I will not send a replacement part until I have received the exchange part from the customer.
As soon as I receive the part I will send out the replacement piece.
The shipping and handling time to replace the part will depend on the USPS delivery time, their average delivery time is approximately 5 days within the continental US.
This guarantee does not cover any labor cost incurred to exchange parts.
A note on International Shipping:
I have listed the USPS First Class Mail International shipping in an attempted to provide a lower cost option for International shipping.
If you choose to have your package shipped by USPS First Class Mail International there is no insurance option.
Also the US Post Office’s approximate time for delivery states that it varies
.
That could mean, your package might be in transit for a few days or a few weeks or more.
If the package is lost there is no recourse, the USPS will not check into lost First Class Mail International.
The only help I could give you is the receipt number and the Customs Form number that would have our names and addresses on it alone with the date of mailing, etc.
Please keep this in mind when choosing to use the USPS First Class Mail International option.
Indemnity coverage is now provided for all ordinary (uninsured) Priority Mail International
(flat-rate envelope not included)
items. This coverage is provided at no additional charge and protects mailers against loss, damage or missing contents. Coverage is calculated based on the weight of the parcel or the value of the contents of the parcel whichever is less.
The estimated delivery time for Priority Mail International is 6 – 10 days.
“International Buyers – Please Note - Customs Duty and Taxes:
The customer is responsible for any custom’s duty and or any tax incurred with the sale.
The customer should also be aware of the fact that if there are any duty or taxes owed, the item
could be
held at customs or the delivering service company until the duty and or the taxes are paid.
Import duties, taxes and charges are
not included
in the item price or shipping charges. These charges are the buyer’s responsibility.
Please check with your country’s customs office to determine what these additional costs will be prior to bidding/buying.”
“These charges are normally collected by the delivering freight (shipping) company or when you pick the item up – do not confuse them for additional shipping charges.”
“We do not mark merchandise values below value or mark items as ‘gifts’ - US and International government regulations prohibit such behavior.”
Send me an email if you have any questions about the Blen Dor Single Control (
ndr)
kit.
***
The
Blen Dor Store
is the
“Industry Leader”
in aftermarket aluminum
HVAC system doors for the
99/04 Jeep Grand Cherokee
***
Check our other listings in the
“
Blen Dor Store
”
for the part best suited to your situation.
The Blen Dor Dual Control
(ndr)
kit.
Keep your dual control system with No dash removal.
The Blen Dor Dual Control
(dr)
part.
Use this kit when you have to remove the dash for other repairs.
The Blen Dor Single Control
(ndr)
kit.
Use this kit when the passenger side actuator motor has failed or a blend door failure where you don’t want to remove the dashboard.
The Blen Dor Recirculation Door
(ndr)
fix.
No dash removal. This would be used when you want to save the time or the cost of removing the dashboard.
!!Free!!
with the purchase of a No Dash Removal blend door item!!
The free item is
included in the two No Dash Removal Combination Items
Previous Blen Dor Store customers who have purchased a no dash removal item are also eligible for the free “Blen Dor Recirculation Door (ndr) fix – But will have to pay shipping costs of .10