1" 24V AC NORMALLY OPEN Electric Brass Solenoid Valve Gas Water 24 Volts VAC

Description

Untitled Document
Normally Open
– closes when power is applied
Gravity Feed Capable
– No Minimum Pressure
24 Volt AC Solenoid Valve
Function
Normally Open
Connection
1” Inch FNPT
Temperature Range
15 – 250F
Pressure Range
0 – 90 PSI
Power Requirements
28VA - 28 Watts
*Suitable Media
Water – Air - Fuel
Specifications
Body Material
Brass
Components
Stainless Steel
Seal Material
Viton® Diaphragm
Operation Type
Semi-Direct Lift Valve
Coil Connection
DIN Connector
Orifice Size
25 mm
Cv Value
12
*Duty Cycle
100% but not indefinitely
Weight
2 lbs 7 oz
Height
5.00"
Length
3.20" port to port
Width
2.60"
Connection – No Polarity, + and
– can be interchanged.
The valve timing is uncertain, however it is fast acting. Less than one second.
Vacuum function is possible with the valve installed in the reverse position.
Mounting position is preferably coil up but can be mounted in any position.
*Consult a chemical compatibility expert for correct seal and valve body material choice.
*Duty Cycle – Like most solenoid valves the coil will become hot to the touch when left on continuously. The temperature will stabilize without failure. Leaving the valve powered on for long periods of time will reduce the life of the coil. Whenever possible the valve should be installed in a well ventilated are to increase the life of the coil. The valve is not intended to be left energized as a fail-safe for power outages. In this case please contact us for other options.
A pre-filter is always recommended to keep the diaphragm free from debris and the valve functioning properly.
Listing and template services provided by inkFrog